Monaghan AeroEclipse Reusable Breath Actuated Nebulizer (RBAN)

More Information

Following the below given steps will ensure that you get the most out of your nebulizer treatment. Please ensure that your hands are washed well before starting the treatment.

Setting up AeroEclipse R BAN:

• Inspect AeroEclipse Reusable Breath Actuated Nebulizer and ensure the exhalation valve on the mouthpiece is pointing down.
• Place your compressor on a clean, flat surface or table top.
• Carefully place prescribed medication into the nebulizer cup and replace the nebulizer top.
• Ensure the nebulizer is kept in an upright position so your medication does not spill.
• Connect the EZ Twist Tubing to the bottom of the nebulizer and the other end to the air outlet on your compressor. Ensure both ends are securely attached.

Using AeroEclipse R BAN:

• In a comfortably seated position, switch on your compressor.
• Place the mouthpiece gently in your mouth. Ensure that your lips are sealed around the edge but do not cover the exhalation valve.
• If you are using an AeroEclipse mask, place it securely over the nose and mouth, ensuring a good seal.
• Breathe in slowly and deeply, then exhale normally through the device.
• Always make sure that there is a good seal around the mouthpiece or mask.
• Take slow, deep breaths continuously, until the noise created by the device changes – referred to as "sputter" sometimes.
• When your treatment is complete, switch off your compressor.

How to Clean AeroEclipse R BAN?

• Clean AeroEclipse BAN Nebulizer after each use and disinfect it as least once every other treatment day.
• May be cleaned on the top shelf of dishwasher or disinfected with vinegar or by boiling.
• Allow all parts to dry thoroughly before reassembling and store them in a dry, dust-free place.

AeroEclipse Reusable Breath Actuated Nebulizer User Guide
 

Customer Reviews