Nidek Nuvo Lite Mark 5 Liter Oxygen Concentrator

More Information

• Allied Simple Medium Concentration Oxygen Mask 
• Salter Style 1600 Series Adult Clear Nasal Oxygen Cannula 

How to operate Oxygen Concentrators?

Starting Up/ Installation

1. Ensure that the switch is in the O (OFF) position. 
2. For use without Humidifier Bottle connect the cannula directly to the concentrator oxygen product outlet. Simply slide the cannula over the oxygen outlet.
3. If a Humidifier Bottle is prescribed: Unscrew the lid from the bottle and fill with water, per the humidifier bottle manufacturers recommendation. Re-attach the lid to the bottle and connect to the oxygen concentrator. Place the bottle on the concentrator and secure with the attachment straps Connect the clear plastic tube supplied to the Humidifier Bottle by use of the DISS fitting. Connect the other end of the tube to the oxygen outlet. Connect the cannula to the outlet on the Humidifier Lid.
   
   Note: The tube between the cannula and the Mark 5 Nuvo Lite should be limited to 20 meters (60 feet) long.
    
4.  Ensure that all of the parts are connected correctly to avoid leaks. No Humidifier Bottle. This illustration shows the Cannula attached directly to the oxygen product outlet connection on the concentrator. This illustration shows the Humidifier Bottle in place. A tube is attached to the DISS fitting on the bottle lid and to the oxygen product outlet connection. The cannula is attached to the outlet on the bottle lid. 
5.  Plug the power cable into a power outlet of the correct voltage and frequency as defined on the manufacturers technical label. 
6.  Press the power switch (I/O) to the ON position (I). The green indicator light glows indicating power is available.
    
7. Note: The required oxygen concentration is normally obtained within five minutes after the unit is started.






 
8.  
9.  
10.  
11. Turn the flow adjustment knob to the prescribed value. This knob may have already been locked in the medically prescribed position. In this case, do not force it. Only the technician or medical personnel are authorized to release it.
12. Check the oxygen flow out of the administration device (nasal cannula or other) by placing it near the surface of a glass of water. The flow should disturb the surface of the water 
13. Adjust the nasal cannula to suit your face, at the end of the treatment, press the I/O Switch to place it in the O (OFF) position to stop the device.
14. The oxygen enriched air flow continues for approximately one minute after the device is stopped.
     

Cleaning

• Only the outside of the Mark 5 Nuvo 8 is to be cleaned, with a soft, dry cloth or, if necessary, a damp sponge, then thoroughly dried with wipes and an alcohol based solution. Acetone, solvents or any other inflammable products must not be used. Do not use abrasive powders.
• The removable cabinet air filter must be cleaned in warm water and household detergent weekly or after approximately 100 hours of use. More frequent cleaning is recommended in dusty environments. Dry before reinstalling.
   

Daily disinfection

•  Because there is a final product filter inside the device, daily disinfection concerns only the external oxygen therapy accessories: humidifier, probes, nasal cannulas (refer to the respective instructions for use).
•  The device must be switched off when alcohol based solutions are used.
• The following minimum guidelines must be observed:
• Humidifier: (If prescribed by a physician)
  - Clean according to the manufacturer's instructions. If no instructions are provided, do the following
• Daily
  - Empty the water from the humidifier
  - Rinse the humidifier flask under running water
  - Fill humidifier up to the mark with distilled water
• Regularly
  - Disinfect the humidifier parts by immersing them in a disinfectant solution (in general, we recommend using a solution of 1 part vinegar diluted with 10 parts water)
  - Rinse and dry
  - Check that the humidifier lid seal is in good condition
• Oxygen tubing and nasal cannula
  - Follow the manufacturer’s instructions
• For each new patient
  - Follow the instructions from the humidifier manufacturer
  - The MARK 5 Nuvo LITE cabinet should be cleaned and disinfected as per the above instructions. The cabinet air filter should be washed or replaced. The entire oxygen administration circuit (oxygen therapy nasal cannulas, etc.) must be changed.
• Maintenance
  - No special maintenance needs to be carried out by the patient. Your equipment supplier performs periodic maintenance operations to assure continued reliable service from the Mark 5 Nuvo Lite.

Specification

Warranty

Limited 3 Year

Customer Reviews