Torbot Solvent Adhesive Remover

More Information

• Instructions for use:
  Removing Appliances:
  - Saturate a ball of cotton or use an eyedropper and apply a few drops of solvent at the top of disc between it and skin. Gently pulling the disc away from the body as the solvent penetrates down between the disc and skin. Apply more as needed until removal is achieved
  Thinning Cement:
  - If Torbot Bonding Cement should become too thick, it can be thinned by adding up to 2oz. of Torbot Solvent per 4oz. can of cement. Add 1/2 ounce at a time and allow to sit for at least 8 hours. Mix well
  Cleaning Cement From Skin:
  - Saturate a cotton ball or gauze with Torbot Solvent. Rub over cement until cement begins to loosen. Rub with a clean dry cloth. Follow same procedure for removing accumulated cement or solvent based adhesives from pouches or discs
• Fire and Explosion Hazards:
  - Material is highly volatile and readily gives off vapors which may travel along the ground or be moved by ventilation and ignited by pilot lights, other flames, sparks, heaters, smoking, electric motors, static discharge, or other ignition sources at locations distant from material handling point. Never use welding or cutting torch on or near drum (even empty) because product (even just residue) can ignite explosively
• Extinguish Media:
  - Foam
  - Carbon Dioxide
  - Dry Chemical
  Firefighting Instructions:
  - Water may be ineffective. Water may be used to keepfire-exposedcontainers cool until fire is out
  - Wear a self-contained breathing apparatus with a full face piece operated in the positive pressure demand mode with appropriated turn-out gear and chemical resistant personal protective equipment
• Protection Information
  Respiratory:
  - If workplace exposure limit(s) of product or any component is exceeded, a NIOSH/MSHA approved air supplied respirator is advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators (negative pressure type) under specified conditions. Engineering or administrative controls should be implemented to reduce exposure
  Eye:
  - Chemical splash goggles in compliance with OSHA regulations are advised; although OSHA regulations also permit other type safety glasses. Consult your safety representative
  Skin:
  - Recommend wearing resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots
• Emergency and First Aid Procedures
  Inhalation Exposure:
  - Breathing small amounts of this material during normal handling is not likely to cause harmful effects
  - If irritation occurs remove to fresh air
  - If experiencing breathing difficulty, seek medical attention
  Eye Contact:
  - May cause mild eye irritation
  - Remove contact lenses
  - Rinse eyes with water
  - If necessary seek medical attention
  Skin Contact:
  - May cause mild skin irritation
  - Prolonged or repeated contact may dry the skin
  - Wash exposed area with mild soap and water
  - If irritation occurs, seek medical attention
• Handling and Storage Procedures
  - Store in a cool, dry area in ambient temperature
  - Keep tightly closed containers away from heat, direct sunlight or other sources of ignition